Machine Type : YB, B, N, NL, LH, GN, GB
¦Click the photos |
 |
 |
| @ Remove the seal wire holder. |
A Take off dirty base tape. |
B Clean or wipe alcohol or thinner etc. |
 |
 |
 |
| C Wipe the surface of seal bar before set the base tape. |
D Set the base tape stretching carefully (2 sheets). |
E Two sheets of base tape should be set moving respectively. |
 |
 |
 |
| F Cut the tape at necessary point to avoid take-off from bending part. |
G End of the tape should be bent. |
H Put insulation plate upon the seal wire holder. |
 |
 |
|
| I Set the screw temporary. |
J Adjust the tape position, confirm suitable setting and then tighten the screw firmly. |